Stieber ASNU 35 Sprag Clutch Bearing 35mm I.D., 80mm O.D., 31mm Race Width
High-performance sprag clutch bearing designed for reliable torque transmission.
Manufacturer part number: ASNU 35
Ships to: France, Monaco For shipping outside these regions, please contact customer support.
Inside Diameter = 35mm
Outside Diameter = 80mm
Torque = 383Nm
Race Width = 31mm
Series = 63
Over-running Speed = 1200 (Inner) rpm, 1900 (Outer) rpm
Keyway = Inner and Outer Race
Drag Torque = 16Ncm
Type ASNU is a roller type freewheel non-bearing supported. Bearings are required to support axial and radial loads. Lubrication and sealing must also be provided by the installation. A typical arrangement is to install this type alongside a bearing within the same location tolerances. The inner race is keyed to the shaft. The outer race has positive n6 tolerance, to give a press fit in a H7 housing. Additional side notches in the outer race provide for positive torque transmission. If the housing is to K6 tolerance, use of the notches is not necessary, but the housing must be strong enough to not expand after assembly. This design can accept an axial misalignment of inner and outer race of ± S/2.
