3D WallArt Flows Wall Panel 3m2

This set of 12 3D WallArt Flows wall panels 3m2 is made from sugar cane fibres. Ideal for decorating your walls and dressing an interior. In a restaurant, a hotel, or simply at home, these panels bring design and elegance to your environment. They can be painted in any colour using acrylic paint. The 12 panels will allow you to decorate your wall.

• Modern and stylish
• Suitable for all rooms (living room, bedroom, kitchen, bathroom, etc.)
• Easy to install

• Packaging: 12 panels, totalling 3m2
• Dimension: 500x500mm with +/-0.5mm on each side
• Weight: 275g
• Thickness: +/- 1.75mm (Tolerance of 0.5mm)
• Panel thickness: +15mm
• Material: Sugar cane fibre
• Surface: smooth
• Flammability: Class C
• Acoustic: Acoustic insulation properties
• Ref. 7225800010

Advice:

If a panel is damaged, it is possible to apply a coating or to replace the panel only.

Installation:

Step 1:
The WallArt panels must first be placed in the room where they will be installed for 48 hours to acclimatise.
This product is designed to be installed on flat, dry surfaces that are free from defects. Any holes or major damage must be repaired before installation.

Step 2:
Apply glue to all edges of each panel.
Also apply glue to all other flat areas on the back of the panel.
Exert even pressure across the entire panel during installation. Don’t forget the corners!
Align each installed panel.

Step 3:
How to cut the panel
Measure the area where you will install the panel, then mark the dimensions with a pencil on your slab.
Cut using a utility knife, starting with a light first pass (a saw or jigsaw can also be used).
Go over the initial cut, cutting deeper into the panel.
Sand the cut edge to make it smooth.

Step 4:
Allow the installation to dry for 4 to 6 hours.

Step 5 (optional):
Applying joints (a joint-free installation is also possible)
Clean the joints with a brush.
Fill the joints with paintable acrylic sealant or filler (plaster is not recommended).
Clean the joints with a damp brush and smooth the joints with your finger.

Step 6:
The panels are now ready to be painted.

Step 7:
Apply a primer to the installed panels (spray, brush, or roller). This step is recommended but not mandatory.
Allow to dry.
Paint the wall following the instructions of the chosen paint (spray, brush, or roller).

Step 8:
Your installation is now complete!

A set of 12 3D WallArt Flows wall panels 3m2
Delivered in its original packaging.