3D WallArt Bricks Wall Panel 3m2

This set of 12 3D wall panels WallArt Bricks 3m2 is made from sugar cane fibres. Ideal for decorating your walls and enhancing an interior. In a restaurant, a hotel, or simply at home, these panels bring design and elegance to your environment. They can be painted in any colour using acrylic paint. The 12 panels will allow you to decorate your wall.

• Modern and stylish
• Suitable for all rooms (living room, bedroom, kitchen, bathroom, etc.)
• Easy to install

• Packaging: 12 panels, totalling 3m2
• Dimension: 500x500mm with +/-0.5mm on each side
• Weight: 275g
• Thickness: +/- 1.75mm (Tolerance of 0.5mm)
• Panel thickness: +15mm
• Material: Sugar cane fibre
• Surface: smooth
• Flammable: Class C
• Acoustic: Acoustic insulation properties
• Ref. 7223042927

Advice:

If a panel is damaged, it is possible to apply a coating or replace only the panel

Installation:

Step 1:
The WallArt panels must first be placed in the room where they will be installed for 48 hours to acclimatise.
This product is designed to be installed on flat, dry surfaces free of defects. Any holes or major damage must be repaired before installation.

Step 2:
Apply glue to all edges of each panel
Also apply glue to all other flat areas on the back of the panel.
Exert even pressure across the entire panel during installation. Don’t forget the corners!
Align each installed panel

Step 3:
How to cut the panel
Measure the area where you will install the panel and then mark the dimension with a pencil on your slab.
Cut using a utility knife, starting with a light first pass (a saw or jigsaw can also be used).
Go over the initial cut, cutting deeper into the panel
Sand the cut edge to make it smooth

Step 4:
Allow the installation to dry for 4 to 6 hours.

Step 5 (optional):
Installing the joints (a joint-free installation is also possible)
Clean the joints with a brush
Fill the joints with paintable acrylic sealant or filler (plaster is not recommended)
Clean the joints with a damp brush and smooth the joints with your finger

Step 6:
The panels are now ready to be painted

Step 7:
Apply a primer to the installed panels (spray, brush, or roller). This step is recommended but not mandatory
Allow to dry
Paint the wall following the instructions of the chosen paint (spray, brush, or roller).

Step 8:
Your installation is now complete!

A set of 12 3D wall panels WallArt Bricks 3m2
Delivered in its original packaging