SOLOPLAST bodywork renovation pack

Ideal for giving your bodywork a fresh look, this SOLOPLAST pack consists of a touch-up pen, a polishing paste, and a kit to renovate your headlights. The three products complement each other for an optimal result: erase scratches and polish the bodywork and headlights.

Transparent Bodywork Touch-Up Pen Pro 9ml:

• Touch-up: bodywork (car, motorcycle, scooter, bicycle, etc.), household appliances, plastic surfaces
• Dries quickly
• Protects against rust

Polishing Paste 200g:

• Restores shine and the look of new to plastic, gel-coat, plexiglass, paints, etc.

Headlight Renovation Pro:

• Treats headlight opacity
• UV protection
• Glossy finish
• High resistance to abrasion and detergents
• Does not yellow

Transparent Bodywork Touch-Up Pen Pro 9ml:

• Volume: 9ml
• Colour: transparent
• Touch-up: bodywork (car, motorcycle, scooter, bicycle, etc.), household appliances, plastic surfaces
• Dries quickly
• Protects against rust
• Ref. 155516

Polishing Paste 200g:

• Volume: 200g
• Supports: plastic, gel-coat, plexiglass, paints...
• Ref. 146842

Headlight Renovation Pro:

• Contains: a 200ml aerosol, 4 abrasives (P400-P600-P800-P320), a degreasing wipe, and a cloth.

Transparent Bodywork Touch-Up Pen Pro 9ml:

• Surface: The surface must be clean, dry, and free of dust or any greasy marks.
• Application: Shake the pen vigorously for 1 minute and perform a test stroke of at least 2 cm before use. - Press the tip onto the area to be treated. Allow to dry for 30 minutes. - Do not wash the vehicle for 72 hours. - Wipe the tip after each use. - For optimal results, use the Soloplast Renovating Paste at least 24 hours after applying the Transparent Touch-Up Pen.
• WARNING: DO NOT USE ON A HOT BODYWORK.

Polishing Paste 200g:

• Apply the renovating paste vigorously in circular motions using cotton or a soft cloth on the surface to be treated. Finish with intensive polishing using another soft cloth.
• Store in a temperate place between 10 and 20°C.
• Use Soloplast products with caution. Before use, read the label and product information.

Headlight Renovation Pro:

• Sand dry using abrasives P400, P600, and P800 to remove the film from the headlight.
• Remove deep scratches using abrasive P320.
• Remove dust and residues from sanding.
• Clean the headlights with the degreasing wipe.
• Wipe with the blue cloth.
• Apply the aerosol in three passes after shaking for 1 minute (until the beads rattle) at 20 cm from the area to be treated.
• A first thin layer for perfect adhesion and to avoid any drips, allow to dry for a few minutes, then apply a horizontal layer followed immediately by a vertical layer.

SOLOPLAST bodywork renovation pack:
1 x Transparent Bodywork Touch-Up Pen Pro 9ml
1 x Polishing Paste 200g
1 x Headlight Renovation Pro kit

Delivered in their original packaging