Polyethylene cover to protect boats during storage. It comes in rolls of 50 m, with two continuous elastics inserted on the outer edges. Installation instructions: 1) Unroll the cover from the stern to the bow, keeping it centered on the boat and leaving an excess of about 50 cm on each side. 2) Apply two straps spaced about 30 cm apart and cut the cover used from the rest of the coil. 3) Pull out

Product Description

Polyethylene cover to protect boats during storage. It comes in rolls of 50 m, with two continuous elastics inserted on the outer edges.

Installation Instructions

1. Unroll the cover from the stern to the bow, keeping it centered on the boat and leaving an excess of about 50 cm on each side.
2. Apply two straps spaced about 30 cm apart and cut the cover used from the rest of the coil.
3. Pull out the elastics and tie them.
4. Open the cover on the boat.
5. Pull the elastic from one end and tie it to keep it under tension.
6. Use the appropriate pre-cuts with reinforcements if necessary to connect the perimeter elastic transversely.