Luxury Plasti Dip Aluminium Spray Paint 400 ml

Luxury Plasti Dip Aluminium Spray Paint 400 ml the undisputed reference for effortlessly repainting all surfaces!
Plasti Dip is an ultra-durable liquid elastomer coating.
Flexible, soft, and resistant, it does not crack, does not chip, and provides adhesion. It resists mould, small impacts, scratches and scuffs, abrasion, seawater, weather conditions, electric arcs, corrosion, and even the Karcher!
It can be applied to all surfaces with no preparation other than a simple degreasing. It dries in the air in 30 minutes and can be removed very easily without any trace or damage to paints and varnishes.

Application:
Plasti Dip is used to cover, decorate, protect, seal, identify, insulate acoustically and electrically, waterproof... in a wide range of sectors such as aeronautics, automotive, watchmaking, etc.

Instructions for use:
Shake vigorously for at least 1 minute as soon as the ball starts to move
Spray the surface to be treated in a back-and-forth motion at a distance of 20 to 30 cm
Wait at least 30 minutes between each coat
Apply as many coats as necessary (a minimum of 3 coats is recommended)
Wait at least 4 hours for complete drying

Usage tips:
Mask off any areas to be protected
Use the aerosol in dry weather, sheltered from the wind, in a well-ventilated area
Store the aerosol in a dry place
Only use the aerosol for its intended purpose

• Colour: red
• Finish: metallic
• Spray
• Capacity: 400 ml
• Coverage: 3m²
• Opacity (tested with black): achieved with 4 coats
• Anti-drip power: excellent
• Tensile strength (according to ASTM D-638 2 6 daN/m²): excellent
• Elongation (according to ASTM D-638): 430%
• Cut resistance (according to ASTM D-1044): excellent
• Stone abrasion: excellent
• Chemical resistance to acids, alkaline products, seawater, chlorine or caustic ammonia solutions: excellent
• Chemical resistance to petroleum solvents and acetone: low
• Insulating properties according to ASTM D-149: 1200 V/mm
• Operating temperature: from -34°C to +93°C
• Shore A hardness (according to ASTM D-2240): 70
• Viscosity at 25°: from 80 to 100 Krebs Units
• Salt fog resistance (according to ASTM B-117): over 1000 hours
• Weather resistance (according to ASTM G-53): 7 to 10 years
• Dust permeability (according to ASTM E-96): 0.03 grains/square foot/hour

1x Luxury Plasti Dip Aluminium Spray Paint 400 ml