Hard Grade - Special Polish Floury Gelcoat - Step 1

HARD GRADE - Special floury gelcoat polish - Step 1

Cream intended for the renovation of the gelcoat.

Allows for the removal of the floury appearance of the gelcoat by lightly abrading the surface of the gelcoat without scratching it.

Contains silica particles.

Its formula enhances the polishing action and deeply strengthens the gelcoat.

HARD GRADE is a very compact paste intended for the renovation of the gelcoat. 

It allows for the removal of the floury appearance of the gelcoat by lightly abrading the surface of the gelcoat without scratching it.

HARD GRADE contains silica particles.

It does not contain aromatic solvents, trichloroethane 111, trichloroethylene, methylene chloride, perchloroethylene, or other halogenated derivatives.

After applying the floury gelcoat polish, it is recommended to use the finishing polish Poli+ - Step 2 to restore the initial shine of the gelcoat.

Instructions for use

By hand:

Apply HARD GRADE to the surface to be treated using a soft, lint-free cloth.

Spread the product.

Always work small areas at a time (50cm by 50cm).

Wait a few seconds to allow the dirt to soak in.

Perform an even polishing, focusing on heavily dulled areas (circular motions).

Finish by wiping with a clean, dry cloth, rubbing to give shine.

With a polisher:

Apply HARD GRADE to the cotton pad.

Always work on a small area (50cm by 50cm).

When the surface is well cleaned, take a clean, dry cotton pad and polish to give shine.

The recommended working speed is 1000-1500 revolutions per minute.

Coverage for a 700g pot: +/- 10-12 m2.

HARD GRADE Characteristics - Special floury gelcoat polish - Step 1

• Physical state: Cream
• Density: 1400 g/l (+ or - 20 g/l).
• Colour: white
• Odour: virtually odourless
• Storage: from +5°C to + 40 °C.
• Coverage: 10-12 m2
• Weight: 650 Gr