VC Offshore Hard Matrix Antifouling
The fast-drying antifouling formulation from VC Offshore EU produces a thin, hard film that can be sanded for a very smooth finish.
This product is therefore perfect for motorboats and sailing boats as it promotes speed and efficiency.
VC Offshore EU is an effective antifouling against marine organisms; slime, plant and animal fouling.
A hard matrix antifouling intended for leisure boaters and professionals.
Effective in both fresh and saltwater. Quick and easy application. No sanding between coats.
Short drying time for quick overcoating and flexible launch deadlines.
The smooth film offers a hard and cleanable finish for increased speed and efficiency. Ideal for racing boats and motorboats.
APPLICATION AND USE
Preparation
VC Offshore
Wash with fresh water.
OTHER ANTIFOULINGS
Ensure good condition.
BARE POLYESTER
Use VC General Thinner to thoroughly clean and degrease the surface.
Lightly sand with 240 grit abrasive.
Perform a high-pressure wash with fresh water and allow to dry.
Use VC Tar2 as a primer or in an osmotic preventive system.
STEEL
Use VC Tar2 as a corrosion-resistant primer.
LEAD
Apply VC Tar2 as a primer coat.
WOOD
Apply Primocon.
Tips
Mixing
Mix well before use.
Pour the powder (contained in the plastic bag) into the container.
Mix well.
Once mixed, the product can be used for up to 7 days, provided it is sealed perfectly after use and mixed well before application.
Cleaner
YTA600 VC General Thinner
Application
Airless Pressure
176-210 bars. Nozzle size: 517-521.
Conventional Gun
Pressure: 23 bars. Nozzle size: 1.51.8mm
Other
For Airmix gun application: Pressure: 2 bars. Nozzle size: 20-113.
A Few Important Points
The final colour will be achieved after immersion.
Ensure to apply the entire recommended quantity, even if it requires applying an additional coat.
To avoid any accelerated aging of the system, ensure that the applied quantities are respected, using the recommended coverage as a guide.
The product temperature should be between 5°C and 35°C.
The ambient temperature should be between 5°C and 35°C.
The substrate temperature should be at least 1°C above the dew point and less than or equal to 35°C.
Compatibility/Substrates
Gelcoated polyester, Wood, Steel/Iron, Lead.
Do not use on aluminium/light alloys or galvanized surfaces.
Suitable for polyester, wood, steel, and lead.
Can be directly applied over most antifoulings, provided they are in good condition, except for PTFE antifoulings.
Number of Coats
By Roller
Apply 2 coats of 30 microns dry for 12 months (total dry thickness of 60 microns)
By Spray Gun (Professional applicators only):
Apply 1 coat of 60 microns dry for 12 months (total dry thickness of 60 microns)
Apply an additional coat on areas subjected to higher abrasion such as rudder, leading edges.
Coverage Rate
By Roller
Theoretical: 12 m²/l
Practical: 10.8 m²/l
By Spray Gun (Professional applicators only)
Theoretical: 6 m²/L
Practical: 3.6 m²/L
Recommended dry film thickness per coat
30 microns dry per coat by roller
60 microns dry per coat by spray gun
Recommended wet thickness per coat
83 microns wet per coat by roller
167 microns wet per coat by spray gun
Application Methods
Airless application (professionals only)
Conventional gun (Applicator
