Flat Washer Type (L) Nylon 6.6

Large Flat Washers Type L

Nylon

Standards

DIN 9021 (ISO 7093, NFE 25-513/25-514, UNI 6593)

How to choose the right washer for your screw?

To choose the right washer for a screw, you need to consider the diameter of the screw, the material of the washer, the type of washer, the load supported, and the applicable standards. The washer must be suitable for the diameter of the screw; otherwise, it will not be able to fulfill its role of protection and load distribution. The washer should be chosen based on the load supported by the screw. Washers are designed to distribute the load over a larger surface area, which can improve the strength of the fastening (the larger the washer, the greater the load it can support).

Discover all types of washers here

Material Information

Nylon 6.6

Polyamide PA 6.6 (commercial name "nylon"). Nylon 6.6 is 7 times lighter than steel, making it a wise choice for reducing weight or mass. It also has high thermal, mechanical, and chemical resistance, as well as excellent electrical insulation properties. Additionally, it can be easily recycled for chemical reuse or energy recovery. Finally, it is non-oxidizing, resistant to fresh water, seawater, and salt mist, which significantly reduces the risk of corrosion and seizing. Its maximum continuous use temperature is 120°C and -30°C minimum. The melting point is at 255°C.

ISO / DIN Standards

This product meets the DIN 9021 standards (similar to ISO 7093, NFE 25-513/25-514, UNI 6593). These standards ensure professional quality and simpler identification of similar products.

Technical Dimensions

Below is the table of technical dimensions (according to size):

Newsletter Subscription

Subscribe to our Newsletter:

I accept the terms and conditions and the privacy policy