Loading
An inverter converts DC voltage to AC voltage, enabling your yacht to run mains power. Our best selling inverters include Phoenix inverter 500/1000w 12v, Victron Phoenix inverter 12/3000 smart, and many more.
Manufacturer
Input voltage (V)
Output voltage (V)
Cont. Output Power (Kva)
Manufacturer
Input voltage (V)
Output voltage (V)
Cont. Output Power (Kva)
In stock
Mastervolt Multi Contact Output - 77030500Part NUM 11111-SY10072-77030500
In stock
Navico 4-way video splitter - 000-11096-001Part NUM 11111-HYSM-000-11096-001
In stock
Used Whisper Power WP-GI galvanic isolation transformer 3600VA - 60110100Part NUM 22222-VYC-60110100
In stock
SAE electronic insulation | isolation transformer 12 KVA | 50-100A | 230V | 115VPart NUM 11111-BMC-45131
Victron Energy
In stock
Same functions as the Multiplus system, but it can be connected to 2 independent AC sources (e.g., shore power and generator or 2 generators) and the Quattro system will automatically connect to the active source.Part NUM 14.268.10
In stock
Alfatronix PV3s DC-DC converter 24 - 12V - 6APart NUM 11111-PV3S
In stock
APC smart UPS 19-inch rack mount - SURT1000RMXLIPart NUM 11111-AR-SURT1000RMXLI
In stock
Alfatronix PV3s DC-DC converter 24 - 12V - 6APart NUM 11111-PV3S
In stock
The system combines a pure sine wave inverter with a sophisticated adaptive charging technology battery charger. Compatible with lithium batteries as well. Two AC outputs. In case of power outage from the shore or generator, the device switches to inverter mode to power the connected devices without interruption. The second output is only available when AC source is present. Devices that may drain the battery, such as a boiler, should be connected to this output. Parallel + three-phase function. Up to 6 devices can be connected in parallel. It is possible to connect 3 units of the same type for three-phase current. Up to 6 sets of 3 units can be paralleled. Power control: the multiplus is very powerful and can absorb a lot of power from the shore or generator. With the multicontrol panel (14.270.32), the absorbed power can be controlled by setting a maximum limit. The multiplus, considering the set limit, will only use the remaining energy to charge the batteries. Power assist: in case of a short period of high power demand, the multiplus will compensate for insufficient supply by drawing energy from the battery. When the load decreases, the excess power is used to recharge the batteries. The microprocessor-controlled battery charger has a 4-stage charging system: bulk-absorption-float-storage, similar to the Phoenix/Skylla charger. - Aluminum casing - Protections against short circuit, overload, low or high battery, high ripple frequency, etc.Part NUM 14.268.00
In stock
The system combines a pure sine wave inverter with a sophisticated adaptive charging technology battery charger. Compatible with lithium batteries as well. Two AC outputs. In case of power outage from the shore or generator, the device switches to inverter mode to power the connected devices without interruption. The second output is only available when AC source is present. Devices that may drain the battery, such as a boiler, should be connected to this output. Parallel + three-phase function. Up to 6 devices can be connected in parallel. It is possible to connect 3 units of the same type for three-phase current. Up to 6 sets of 3 units can be paralleled. Power control: the multiplus is very powerful and can absorb a lot of power from the shore or generator. With the multicontrol panel (14.270.32), the absorbed power can be controlled by setting a maximum limit. The multiplus, considering the set limit, will only use the remaining energy to charge the batteries. Power assist: in case of a short period of high power demand, the multiplus will compensate for insufficient supply by drawing energy from the battery. When the load decreases, the excess power is used to recharge the batteries. The microprocessor-controlled battery charger has a 4-stage charging system: bulk-absorption-float-storage, similar to the Phoenix/Skylla charger. - Aluminum casing - Protections against short circuit, overload, low or high battery, high ripple frequency, etc.Part NUM 14.268.00
In stock
It is a special transformer with a single winding equipped with intermediate taps. It greatly reduces hysteresis losses and eliminates the insulation problem between windings, but the primary and secondary are not isolated (unlike a normal transformer). It is often used to increase or decrease voltage in the 110/120 range to the 220/240 range, for example, providing 120V from 240V, allowing the use of 120V equipment with a 240V voltage.Part NUM 14.264.10
In stock
Developed with Sinumax technology for professional use, they guarantee the necessary power with reduced size. The particular feature of Sinumax technology is the high peak power for startups, as required by refrigerators, electric motors, lamps, etc. Technical features include an aluminum casing, forced ventilation with temperature sensors, protection against short circuits, alarm for excessively high or low battery voltage, reverse polarity, output voltage return, etc. If you want the automatic switching function to another AC power source, we recommend the Multiplus inverter/charger, which has this integrated function and you can deactivate only the charger. Phoenix: a) Connection to PC via VE-Bus to USB port. b) Remote on/off. Phoenix Smart: a) Configurable integrated Bluetooth with tablet or smartphone. b) VE-DIRECT serial port for connection to PC via VE-Direct to USB cable. c) ECO mode that puts the inverter in Stand-by if the load drops below a preset value. d) Remote on/off.Part NUM 14.270.15
In stock
Same functions as the Multiplus system, but it can be connected to 2 independent AC sources (e.g., shore power and generator or 2 generators) and the Quattro system will automatically connect to the active source.Part NUM 14.268.10
In stock
It is a special transformer with a single winding equipped with intermediate taps. It greatly reduces hysteresis losses and eliminates the insulation problem between windings, but the primary and secondary are not isolated (unlike a normal transformer). It is often used to increase or decrease voltage in the 110/120 range to the 220/240 range, for example, providing 120V from 240V, allowing the use of 120V equipment with a 240V voltage.Part NUM 14.264.10
In stock
The system combines a pure sine wave inverter with a sophisticated adaptive charging technology battery charger. Compatible with lithium batteries as well. Two AC outputs. In case of power outage from the shore or generator, the device switches to inverter mode to power the connected devices without interruption. The second output is only available when AC source is present. Devices that may drain the battery, such as a boiler, should be connected to this output. Parallel + three-phase function. Up to 6 devices can be connected in parallel. It is possible to connect 3 units of the same type for three-phase current. Up to 6 sets of 3 units can be paralleled. Power control: the multiplus is very powerful and can absorb a lot of power from the shore or generator. With the multicontrol panel (14.270.32), the absorbed power can be controlled by setting a maximum limit. The multiplus, considering the set limit, will only use the remaining energy to charge the batteries. Power assist: in case of a short period of high power demand, the multiplus will compensate for insufficient supply by drawing energy from the battery. When the load decreases, the excess power is used to recharge the batteries. The microprocessor-controlled battery charger has a 4-stage charging system: bulk-absorption-float-storage, similar to the Phoenix/Skylla charger. - Aluminum casing - Protections against short circuit, overload, low or high battery, high ripple frequency, etc.Part NUM 14.268.00
In stock
The system combines a pure sine wave inverter with a sophisticated adaptive charging technology battery charger. Compatible with lithium batteries as well. Two AC outputs. In case of power outage from the shore or generator, the device switches to inverter mode to power the connected devices without interruption. The second output is only available when AC source is present. Devices that may drain the battery, such as a boiler, should be connected to this output. Parallel + three-phase function. Up to 6 devices can be connected in parallel. It is possible to connect 3 units of the same type for three-phase current. Up to 6 sets of 3 units can be paralleled. Power control: the multiplus is very powerful and can absorb a lot of power from the shore or generator. With the multicontrol panel (14.270.32), the absorbed power can be controlled by setting a maximum limit. The multiplus, considering the set limit, will only use the remaining energy to charge the batteries. Power assist: in case of a short period of high power demand, the multiplus will compensate for insufficient supply by drawing energy from the battery. When the load decreases, the excess power is used to recharge the batteries. The microprocessor-controlled battery charger has a 4-stage charging system: bulk-absorption-float-storage, similar to the Phoenix/Skylla charger. - Aluminum casing - Protections against short circuit, overload, low or high battery, high ripple frequency, etc.Part NUM 14.268.00
In stock
Same functions as the Multiplus system, but it can be connected to 2 independent AC sources (e.g., shore power and generator or 2 generators) and the Quattro system will automatically connect to the active source.Part NUM 14.268.10
In stock
Same functions as the Multiplus system, but it can be connected to 2 independent AC sources (e.g., shore power and generator or 2 generators) and the Quattro system will automatically connect to the active source.Part NUM 14.268.10
In stock
Whisper Power WP-MG 24/12-30-i DC-DC converter - 60110021Part NUM 11111-SY10072-60110021
In stock
The system combines a pure sine wave inverter with a sophisticated adaptive charging technology battery charger. Compatible with lithium batteries as well. Two AC outputs. In case of power outage from the shore or generator, the device switches to inverter mode to power the connected devices without interruption. The second output is only available when AC source is present. Devices that may drain the battery, such as a boiler, should be connected to this output. Parallel + three-phase function. Up to 6 devices can be connected in parallel. It is possible to connect 3 units of the same type for three-phase current. Up to 6 sets of 3 units can be paralleled. Power control: the multiplus is very powerful and can absorb a lot of power from the shore or generator. With the multicontrol panel (14.270.32), the absorbed power can be controlled by setting a maximum limit. The multiplus, considering the set limit, will only use the remaining energy to charge the batteries. Power assist: in case of a short period of high power demand, the multiplus will compensate for insufficient supply by drawing energy from the battery. When the load decreases, the excess power is used to recharge the batteries. The microprocessor-controlled battery charger has a 4-stage charging system: bulk-absorption-float-storage, similar to the Phoenix/Skylla charger. - Aluminum casing - Protections against short circuit, overload, low or high battery, high ripple frequency, etc.Part NUM 14.268.00