The Two-Component Epoxy Coating - Epoxycoque 500 ML by Boero YachtCoatings is a fast-drying, solvent-free epoxy filler designed for small repair works on wooden, iron, aluminum, and fiberglass surfaces. Its creamy consistency allows for high-quality sanding treatments, both dry and wet, and can be applied with a maximum thickness of 1 cm per layer. Suitable for use above and below the waterline, Epoxycoque offers excellent adhesion and a durable finish. It is easy to apply using a spatula, trowel, or palette knife, and dries quickly, enabling fast and effective repairs.
- Quick Drying: Allows for rapid repairs.
- Easy Application: Can be applied with a spatula, trowel, or palette knife.
- Excellent Adhesion: Provides strong bonding on various surfaces.
- Usable Above and Below the Waterline: Suitable for all parts of the watercraft.
- Solvent-Free: Environmentally friendly and safe to use.
Technical Specifications:
- Theoretical Spreading Rate: At 300 µm thickness: 3.3 m²/L.
- Mixing Ratio by Volume: 1:1 (resin to hardener).
- Pot Life: Approximately 30 minutes at 20°C.
- Sanding Time: 3 to 4 hours at 20°C before sanding.
- Thinner: Use Boero Thinner 693 for cleaning equipment only.
Materials:
- Component A: Resin.
- Component B: Hardener.
Compatibility Information:
Epoxycoque is compatible with wooden, iron, aluminum, and fiberglass surfaces. For optimal adhesion, it is recommended to prepare the surface with the appropriate primers, such as Boero's Delta 3000 or Defender primers.
Application Tips:
- Surface Preparation: Ensure the surface is clean, dry, and free from oil, grease, or dust. Lightly sand the surface to improve adhesion.
- Mixing the Components: Mix Component A and Component B in a 1:1 volume ratio. Stir thoroughly until a homogeneous mixture is obtained.
- Application: Apply the mixture using a spatula, trowel, or palette knife. Spread a uniform layer with a maximum thickness of 1 cm. For larger repairs, apply multiple layers, allowing each to dry before applying the next.
- Drying: Allow the coating to dry for 3 to 4 hours at 20°C before sanding.
- Sanding: Once dry, sand the surface to achieve a smooth and even finish.
