Transparent mixing nozzle L 170

Amixing nozzle for chemical sealingto be used according to the following instructions. For hollow materials, it is the diameter of the sieve that determines the diameter of the drilling. For solid materials, it is the diameter of the threaded rod that will be your reference, to which you need to add 2mm. Drill the hole to the desired dimensions. Carefully dust the holes by blowing air into them. Insert the resin cartridge and cut the end (discard the first centimetre of mixture). Inject the sealant starting from the bottom of the hole and in sufficient quantity. For hollow materials only: insert the sieve ensuring that the centring ring is open, then inject the resin into the sieve and close the centring ring, then insert the threaded rod during the handling time, turning until it reaches the bottom of the sieve. For solid materials, the same operation is performed but without the sieves. For reference, at a temperature of 5°C the drying time is 50 min, at 20°C wait 20 min, at 30°C wait 15 min, and at 35°C wait 10 min.

Tip: position the cartridge on a gun, remove the cap, screw on the mixing nozzle, pump to release a stream of mortar and check that the mixture is homogeneous, then inject directly according to the required dosage.

• Colour: transparent
• Reusable
• Weight: 10g
• Ref. FIXCANUL170

A transparent mixing nozzle L 170
Delivered in its original packaging