150mm Digital Caliper

Pied à coulisse digital

Pied à coulisse digital. Jauge plate standard. Capacité 150mm x 40mm.

"0" initialised. Crossed jaws.

Standard and Accuracy

Our calipers meet the DIN 862 standard and the reading accuracy is guaranteed.

Technical Information on Digital Measurement Possibilities

Internal and External Measurements

• Clean and closed measuring jaws.
• Select the mm/inches reading.
• Zero and measure.

Difficult Reading Measurements

Measure and zero. Close the jaws and read the value directly on the digital display.

Measuring Parts to be Adjusted

Take the internal measurement, zero it, then take the external measurement. Read the deviation indicated on the digital display.

Depth Measurements and Small Diameters

Place the rule against the part. Slide it so that the depth rod touches the bottom of the cavity. Read the depth directly on the digital display.

Tolerance Measurements

Adjust to the theoretical dimension and set to zero. Perform the comparison check of the machined part and check the digital display. It indicates exactly the upper or lower margin relative to the theoretical dimension.